The Saga 35 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.
The boat can enter most marinas as the draft is just about 1.55 - 1.65 meter (5.09 - 5.39 ft) dependent on the load. See immersion rate below.
Saga 35 is typically equipped with an inboard Yanmar 3JH3E diesel engine at 65.0 hp (48 kW).
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Saga 35 is 1.71, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Saga 35 is about 241 kg/cm, alternatively 1352 lbs/inch.
Meaning: if you load 241 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1352 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Saga 35 is 3.12.
The ballast ratio for Saga 35 is 60%.
What is SA/D (Sail Area Displacement ratio)?
The SA/D for Saga 35 with ISO 8666 reference sail is 16.4, with a 135% genua the SA/D is 19.4.
Dimensions of sail.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Mainsail halyard | 33.8 m | (110.7 feet) | 12 mm | (1/2 inch) |
Jib/genoa halyard | 33.8 m | (110.7 feet) | 12 mm | (1/2 inch) |
Spinnaker halyard | 33.8 m | (110.7 feet) | 12 mm | (1/2 inch) |
Jib sheet | 10.6 m | (34.8 feet) | 14 mm | (0.55 inch) |
Genoa sheet | 10.6 m | (34.8 feet) | 14 mm | (0.55 inch) |
Mainsheet | 26.5 m | (86.9 feet) | 14 mm | (0.55 inch) |
Spinnaker sheet | 23.3 m | (76.5 feet) | 14 mm | (0.55 inch) |
Cunningham | 4.9 m | (16.0 feet) | 12 mm | (1/2 inch) |
Kickingstrap | 9.8 m | (32.0 feet) | 12 mm | (1/2 inch) |
Clew-outhaul | 9.8 m | (32.0 feet) | 12 mm | (1/2 inch) |
This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.
We are always looking for new photos. If you can contribute with photos for Saga 35 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.