Udkik.dk

Review of Sea Ray 268 Sundancer


Basic specs.

sail specifications
The Sea Ray 268 Sundancer is a motorboat designed in the mid eighties. The Sea Ray 268 Sundancer is built by the American yard Sea Ray.

Here we would have liked to show you nice photos of the Sea Ray 268 Sundancer.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Sea Ray 268 Sundancer or similar boat for sale

Hull
The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The hull is a double hull which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.

Interior
The interior is like most other boats made of teak.
The boat is equipped with 2 cabins, 6 berths, a galley and toilet facility.

Keel

The boat can enter even shallow marinas as the draft is just about 0.90 - 1.00 meter (2.95 - 3.25 ft) dependent on the load. See immersion rate below.


Engine

Sea Ray 268 Sundancer is typically equipped with an inboard MerCruiser engine at 330.0 hp (245 kW).

The transmission is a Z-drive.

The fuel tank which is made of stainless steel has a capacity of 420.0 liters (110 US gallons, 92 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Sea Ray 268 Sundancer is about 143 kg/cm, alternatively 805 lbs/inch.
Meaning: if you load 143 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 805 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Sea Ray 268 Sundancer is 3.06.

Wide Slim 66% 0 50 100
Compared with other similar motor boats it is slimmer than 66% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Equation for Danish definition of a powerboat
Danish definition of a powerboat
According to this definition this boat is categorized as a Powerboat.


Maintenance

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Sea Ray 268 Sundancer it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References