Review of Husky Dane 85

Basic specs.

The Husky Dane 85 is a motorboat designed by the maritime architect Halvor Rosenbaum in the mid seventies. The Husky Dane 85 is built by the Danish yard Baess Boats.

Here we would have liked to show you nice photos of the Husky Dane 85.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Husky Dane 85 or similar boat for sale

Hull

The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The deck is a double deck which improves the indoor climate.

Interior

The interior is like most other boats made of teak.
The boat is equipped with 2 cabins, 5 berths, a galley and toilet facility.
Note: the boat has also been sold to be self-made/-interiored, which means that the quality of each boat may vary.

Keel

Husky Dane 85 can enter even shallow marinas as the draft is just about 0.90 - 1.00 meter (2.95 - 3.25 ft) dependent on the load. See immersion rate below.

Engine

The boat is typically equipped with an inboard Yanmar diesel engine at 44.0 hp (32 kW).

The transmission is a shaft drive.

The fuel tank which is made of stainless steel has a capacity of 200.0 liters (52 US gallons, 43 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Husky Dane 85 is about 187 kg/cm, alternatively 1052 lbs/inch.
Meaning: if you load 187 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1052 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Husky Dane 85 is 2.58.

Compared with other similar motor boats it is more spacy than 96% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Danish definition of a powerboat

According to this definition this boat is not categorized as a Powerboat.
Though, if you install a motor of 75 kW (100 hp), then the boat will become a powerboat, and you will need a Danish 'powerboat driving license'

Maintenance

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.

Finally

We are always looking for new photos. If you can contribute with photos for Husky Dane 85 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.