Udkik.dk

Review of Holder 14 Mk II


Basic specs.

sail specifications
The Holder 14 Mk II is a small dinghy designed by the maritime architect Ron Holder in the mid eighties.

Here we would have liked to show you nice photos of the Holder 14 Mk II.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Holder 14 Mk II or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Rig
The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.

Keel

The Holder 14 Mk II is equipped with a daggerboard keel. A daggerboard is a lifting keel that can be lowered and raised, allowing the boat to enter shallow waters as well.

The boat can sail close to the beach as the draft is just 0.15 - 0.25 meter (0.49 - 0.79 ft) dependent of the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Holder 14 Mk II is about 47 kg/cm, alternatively 268 lbs/inch.
Meaning: if you load 47 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 268 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Holder 14 Mk II is 2.22.

Slim Wide 88% 0 50 100
Compared with other similar dinghies it is more spacy than 88% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Maintenance

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Holder 14 Mk II it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References