Review of Adp 52

Basic specs.

The Adp 52 is a large sailboat designed by the maritime architect bureau Finot-Conq et associés in the early 2000. Only a few boats have been produced.

Here we would have liked to show you nice photos of the Adp 52.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Adp 52 or similar boat for sale

Keel

The boat can enter most marinas as the draft is just about 1.70 - 1.80 meter (5.58 - 5.88 ft) dependent on the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Adp 52 is 2.38, indicating that this boat would not be accepted to participate in ocean races.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Adp 52 is about 496 kg/cm, alternatively 2780 lbs/inch.
Meaning: if you load 496 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2780 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Adp 52 is 3.33.

Compared with other similar sailboats it is more spacy than 76% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Adp 52 is 41%.

This ballast ratio shows a righting moment that is higher than 79% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly above average.

Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Jib sheet	15.7 m	(51.5 feet)	16 mm	(5/8 inch)
Genoa sheet	15.7 m	(51.5 feet)	16 mm	(5/8 inch)
Mainsheet	39.2 m	(128.8 feet)	16 mm	(5/8 inch)
Spinnaker sheet	34.5 m	(113.3 feet)	16 mm	(5/8 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.

Finally

We are always looking for new photos. If you can contribute with photos for Adp 52 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.