Udkik.dk

Review of Tetis


Tetis
Tetis.

Basic specs.

sail specifications
The Tetis is a sailboat designed by the maritime architect C. H. Eickhoff.

Looking for a new boat? Find a Tetis or similar boat for sale

Rig
The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.

Keel

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can enter even shallow marinas as the draft is just about 1.35 - 1.45 meter (4.43 - 4.73 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Tetis is 1.77, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Tetis is about 147 kg/cm, alternatively 825 lbs/inch.
Meaning: if you load 147 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 825 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Tetis is 3.52.

Wide Slim 90% 0 50 100
Compared with other similar sailboats it is slimmer than 90% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Tetis is 44%.

Low High 69% 0 50 100
This ballast ratio shows a righting moment that is higher than 69% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Tetis with ISO 8666 reference sail is 15.7, with a 135% genua the SA/D is 18.6.

Low High 46% 0 50 100
The SA/D ratio indicates that it is faster than 46% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 76% 0 50 100
The Tetis has more rig than 76% of all similar sailboats, which indicates that the boat is significantly overrigged.


RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Tetis is 21

Slow Fast 21% 0 50 100
The relative speed performance is 21 which means that a it is faster than 21% of all similar sailboat designs.


Maintenance

Rig

Dimensions of sail for fractional rig.

mainsail specifications spinnaker specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 24.2 m(79.3 feet)8 mm(5/16 inch)
Jib/genoa halyard24.2 m(79.3 feet)8 mm(5/16 inch)
Spinnaker halyard24.2 m(79.3 feet)8 mm(5/16 inch)
Jib sheet 8.8 m(28.9 feet)10 mm(3/8 inch)
Genoa sheet8.8 m(28.9 feet)10 mm(3/8 inch)
Mainsheet 22.0 m(72.2 feet)10 mm(3/8 inch)
Spinnaker sheet19.4 m(63.5 feet)10 mm(3/8 inch)
Cunningham3.2 m(10.5 feet)8 mm(5/16 inch)
Kickingstrap6.4 m(21.0 feet)8 mm(5/16 inch)
Clew-outhaul6.4 m(21.0 feet)8 mm(5/16 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Tetis it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References