Review of Tanzer 10.5

Basic specs.

The Tanzer 10.5 is a sailboat designed by the Canadian maritime architect Johann Tanzer. The Tanzer 10.5 is built by the Canadian yard Tanzer Industries Ltd..

Here we would have liked to show you nice photos of the Tanzer 10.5.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Tanzer 10.5 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Rig

The boat equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

Keel

The Tanzer 10.5 has been built with more than one type of keel.

One option is a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Sorry, we have no sailing characteristics available for this boat.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Over- / underrigged

Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.

Maintenance

Rig

Dimensions of sail for masthead rig.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Mainsail halyard	30.1 m	(98.8 feet)	6 mm	(1/4 inch)
Jib/genoa halyard	30.1 m	(98.8 feet)	6 mm	(1/4 inch)
Spinnaker halyard	30.1 m	(98.8 feet)	6 mm	(1/4 inch)
Cunningham	4.0 m	(13.0 feet)	6 mm	(1/4 inch)
Kickingstrap	7.9 m	(26.0 feet)	6 mm	(1/4 inch)
Clew-outhaul	7.9 m	(26.0 feet)	6 mm	(1/4 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.

Finally

We are always looking for new photos. If you can contribute with photos for Tanzer 10.5 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.