Udkik.dk

Review of Princess 330


Princess 330
Princess 330 anno 1989. Rear of boat

Basic specs.

sail specifications
The Princess 330 is a motorboat designed by the maritime architect Bernard Olesinski in the late eighties. The Princess 330 is built by the British yard Marine Projects.

Looking for a new boat? Find a Princess 330 or similar boat for sale

Hull
The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season.
The hull is a double hull which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.
The deck is a double deck which improves the indoor climate.

Interior
The interior is like most other boats made of teak.
The boat is equipped with 3 cabins, 6 berths, a galley and toilet facility.

Keel

The boat can enter even shallow marinas as the draft is just about 0.80 - 0.90 meter (2.62 - 2.92 ft) dependent on the load. See immersion rate below.


Engine

Princess 330 is typically equipped with dual inboard Volvo Penta TMD 41 diesel engines at 150.0 hp (111 kW).

The transmission is a shaft drive.

The fuel tank which is made of stainless steel has a capacity of 700.0 liters (184 US gallons, 153 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Princess 330 is about 263 kg/cm, alternatively 1477 lbs/inch.
Meaning: if you load 263 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1477 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Princess 330 is 2.79.

Slim Wide 85% 0 50 100
Compared with other similar motor boats it is more spacy than 85% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Equation for Danish definition of a powerboat
Danish definition of a powerboat
According to this definition this boat is categorized as a Powerboat.


Maintenance

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Princess 330 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References