Udkik.dk

Review of Little Harbor 54


Basic specs.

sail specifications
The Little Harbor 54 is a large sailboat designed by the American maritime architect Ted Hood in the late eighties. The Little Harbor 54 is built by the American yard Little Harbor.

Here we would have liked to show you nice photos of the Little Harbor 54.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Little Harbor 54 or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

Rig
The boat equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

Keel

The Little Harbor 54 is equipped with a centerboard keel. A centerboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can only enter major marinas as the draft is about 1.92 - 2.02 meter (6.30 - 6.60 ft) dependent on the load. See immersion rate below.


Engine

The boat is typically equipped with an inboard Westerbeke diesel engine.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Little Harbor 54 is 1.51, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 8.8 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Little Harbor 54 is about 402 kg/cm, alternatively 2256 lbs/inch.
Meaning: if you load 402 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2256 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Little Harbor 54 is 55.9.

Low High 99% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 99% of all similar sailboat designs. This is a comfort value significantly above average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Little Harbor 54 is 3.60.

Wide Slim 54% 0 50 100
Compared with other similar sailboats it is slimmer than 54% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Little Harbor 54 is 30%.

Low High 18% 0 50 100
This ballast ratio shows a righting moment that is higher than 18% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly below average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Little Harbor 54 is 345 which categorizes this boat among 'heavy cruisers'.

Heavy Light 5% 0 50 100
5% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Little Harbor 54 with ISO 8666 reference sail is 12.9, with a 135% genua the SA/D is 15.5.

Low High 1% 0 50 100
The SA/D ratio indicates that it is faster than 1% of all similar sailboat designs in light wind.


Over- / underrigged


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 82m2 (882 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for masthead rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 45.1 m(148.0 feet)14 mm(0.55 inch)
Jib/genoa halyard45.1 m(148.0 feet)14 mm(0.55 inch)
Spinnaker halyard45.1 m(148.0 feet)14 mm(0.55 inch)
Jib sheet 16.5 m(54.0 feet)16 mm(5/8 inch)
Genoa sheet16.5 m(54.0 feet)16 mm(5/8 inch)
Mainsheet 41.2 m(135.0 feet)16 mm(5/8 inch)
Spinnaker sheet36.2 m(118.8 feet)16 mm(5/8 inch)
Cunningham5.9 m(19.4 feet)14 mm(0.55 inch)
Kickingstrap11.8 m(38.8 feet)14 mm(0.55 inch)
Clew-outhaul11.8 m(38.8 feet)14 mm(0.55 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Little Harbor 54 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References