Review of Hanse 345

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

The boat is equipped with a galley.

The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.

The Hanse 345 has been built with more than one type of keel.

One option is a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.But be aware that even though a T keel is very good for speed racing, a fishing nets and the like in the water can easily make you into a troublesome situation.

The boat can only enter major marinas as the draft is about 1.87 - 1.97 meter (6.14 - 6.44 ft) dependent on the load. See immersion rate below.

Hanse 345 is typically equipped with an inboard Volvo Penta D1-20 diesel engine at 18.0 hp (13 kW), which gives a max speed about 4.8 knots.

The transmission is a saildrive.

The fuel tank has a capacity of 160.0 liters (42 US gallons, 35 imperial gallons).

What is Capsize Screening Formula (CSF)?

The capsize screening value for Hanse 345 is 1.92, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Hanse 345 holds one CE certification:

The boat is by European Union certified as Class A. OCEAN:

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 7.5 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Hanse 345 is about 223 kg/cm, alternatively 1254 lbs/inch.
Meaning: if you load 223 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1254 lbs cargo on the boat it will sink 1 inch.

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Hanse 345 is 25.6.

Comparing this ratio with similar sailboats show that it is more comfortable than 54% of all similar sailboat designs. This comfort value is just above average.

What is L/B (Length Beam Ratio)?

The l/b ratio for Hanse 345 is 2.85.

Compared with other similar sailboats it is more spacy than 79% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

What is Displacement Length Ratio?

The DL-ratio for Hanse 345 is 198 which categorizes this boat among 'light racers'.

73% of all similar sailboat designs are categorized as heavier. A light displacement requires less sailarea and has higher accellerations.

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Hanse 345 with ISO 8666 reference sail is 16.2, with a 135% genua the SA/D is 18.9.

The SA/D ratio indicates that it is faster than 42% of all similar sailboat designs in light wind.

The Hanse 345 has more rig than 58% of all similar sailboats, which indicates that the boat is slightly overrigged.

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 38m² (409 ft²).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.

Dimensions of sail for fractional rig.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.

We are always looking for new photos. If you can contribute with photos for Hanse 345 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.