Udkik.dk

Review of Gulfstar 47


Basic specs.

sail specifications
The Gulfstar 47 is a large sailboat designed by the maritime architect Vince S. Lazzara in the late seventies. Less than 100 boats have been produced. The Gulfstar 47 is built by the American yard Gulfstar Inc.

Here we would have liked to show you nice photos of the Gulfstar 47.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Gulfstar 47 or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

Rig
The boat equipped with a ketch rig.

Keel

The Gulfstar 47 is equipped with a long keel. A long keel provide a better directional stability than a similar boat with a fin keel; on the other hand, better directional stability means also that the boat is more difficult to handle in a harbour with less space.

The boat can enter most marinas as the draft is just about 1.68 - 1.78 meter (5.51 - 5.81 ft) dependent on the load. See immersion rate below.


Engine

The boat is typically equipped with an inboard Perkins diesel engine.

The fuel tank has a capacity of 738.0 liters (194 US gallons, 162 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Gulfstar 47 is 1.65, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 8.5 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Gulfstar 47 is about 348 kg/cm, alternatively 1953 lbs/inch.
Meaning: if you load 348 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1953 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Gulfstar 47 is 41.4.

Low High 79% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 79% of all similar sailboat designs. This is a comfort value significantly above average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Gulfstar 47 is 3.42.

Slim Wide 54% 0 50 100
Compared with other similar sailboats it is more spacy than 54% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Gulfstar 47 is 28%.

Low High 15% 0 50 100
This ballast ratio shows a righting moment that is higher than 15% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly below average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Gulfstar 47 is 255 which categorizes this boat among 'light crusers & offshore racers'.

Heavy Light 42% 0 50 100
42% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Gulfstar 47 with ISO 8666 reference sail is 11.3, with a 135% genua the SA/D is 13.7.

Low High 1% 0 50 100
The SA/D ratio indicates that it is faster than 1% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 42% 0 50 100
The Gulfstar 47 has more rig than 42% of all similar sailboats, which indicates that the boat is slightly underrigged.


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 55m2 (592 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for ketch rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 32.5 m(106.8 feet)14 mm(0.55 inch)
Jib/genoa halyard32.5 m(106.8 feet)14 mm(0.55 inch)
Spinnaker halyard32.5 m(106.8 feet)14 mm(0.55 inch)
Jib sheet 14.4 m(47.4 feet)16 mm(5/8 inch)
Genoa sheet14.4 m(47.4 feet)16 mm(5/8 inch)
Mainsheet 36.1 m(118.5 feet)16 mm(5/8 inch)
Spinnaker sheet31.8 m(104.3 feet)16 mm(5/8 inch)
Cunningham4.7 m(15.5 feet)14 mm(0.55 inch)
Kickingstrap9.4 m(31.0 feet)14 mm(0.55 inch)
Clew-outhaul9.4 m(31.0 feet)14 mm(0.55 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Gulfstar 47 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References