The boat can enter even shallow marinas as the draft is just about 0.90 - 1.00 meter (2.95 - 3.25 ft) dependent on the load. See immersion rate below.
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Drayer is about 77 kg/cm, alternatively 432 lbs/inch.
Meaning: if you load 77 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 432 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Drayer is 2.91.
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
---|---|---|---|---|
Jib sheet | 5.8 m | (19.0 feet) | 8 mm | (5/16 inch) |
Genoa sheet | 5.8 m | (19.0 feet) | 8 mm | (5/16 inch) |
Mainsheet | 14.5 m | (47.5 feet) | 8 mm | (5/16 inch) |
Spinnaker sheet | 12.7 m | (41.8 feet) | 8 mm | (5/16 inch) |
This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.
We are always looking for new photos. If you can contribute with photos for Drayer it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.