Udkik.dk

Review of Catalina 42 Mk II


Basic specs.

sail specifications
The Catalina 42 Mk II is a large sailboat designed by the maritime architect Gerry Douglas in the mid nineties. Several hundred boats have been produced. The Catalina 42 Mk II is built by Catalina Yachts.

Here we would have liked to show you nice photos of the Catalina 42 Mk II.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Catalina 42 Mk II or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

Rig
The boat equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

Keel

The Catalina 42 Mk II is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.

The boat can only enter major marinas as the draft is about 1.83 - 1.93 meter (6.00 - 6.30 ft) dependent on the load. See immersion rate below.


Engine

The boat is typically equipped with an inboard Yanmar 4JH2-E diesel engine.

The fuel tank has a capacity of 144.0 liters (38 US gallons, 31 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Catalina 42 Mk II is 2.02, indicating that this boat would not be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 8.0 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Catalina 42 Mk II is about 310 kg/cm, alternatively 1736 lbs/inch.
Meaning: if you load 310 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1736 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Catalina 42 Mk II is 25.2.

Low High 24% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 24% of all similar sailboat designs. This is a comfort value significantly below average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Catalina 42 Mk II is 3.02.

Slim Wide 82% 0 50 100
Compared with other similar sailboats it is more spacy than 82% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Catalina 42 Mk II is 40%.

Low High 54% 0 50 100
This ballast ratio shows a righting moment that is higher than 54% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Catalina 42 Mk II is 196 which categorizes this boat among 'light racers'.

Heavy Light 73% 0 50 100
73% of all similar sailboat designs are categorized as heavier. A light displacement requires less sailarea and has higher accellerations.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Catalina 42 Mk II with ISO 8666 reference sail is 17.0, with a 135% genua the SA/D is 20.3.

Low High 42% 0 50 100
The SA/D ratio indicates that it is faster than 42% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 58% 0 50 100
The Catalina 42 Mk II has more rig than 58% of all similar sailboats, which indicates that the boat is slightly overrigged.


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 50m2 (538 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for masthead rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 36.9 m(121.1 feet)12 mm(1/2 inch)
Jib/genoa halyard36.9 m(121.1 feet)12 mm(1/2 inch)
Spinnaker halyard36.9 m(121.1 feet)12 mm(1/2 inch)
Jib sheet 12.8 m(41.9 feet)14 mm(0.55 inch)
Genoa sheet12.8 m(41.9 feet)14 mm(0.55 inch)
Mainsheet 31.9 m(104.7 feet)14 mm(0.55 inch)
Spinnaker sheet28.1 m(92.1 feet)14 mm(0.55 inch)
Cunningham4.7 m(15.5 feet)12 mm(1/2 inch)
Kickingstrap9.4 m(31.0 feet)12 mm(1/2 inch)
Clew-outhaul9.4 m(31.0 feet)12 mm(1/2 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Catalina 42 Mk II it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References