The First 25.7 has been built with more than one type of keel.
One option is a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.
Another option is a centerboard keel. A centerboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.
The boat can enter even shallow marinas as the draft is just about 1.45 - 1.55 meter (4.76 - 5.06 ft) dependent on the load. See immersion rate below.
The boat is typically equipped with an inboard Nanni diesel engine.
The fuel tank has a capacity of 30.0 liters (7 US gallons, 6 imperial gallons).
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for First 25.7 is 2.16, indicating that this boat would not be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 6.6 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for First 25.7 is about 135 kg/cm, alternatively 761 lbs/inch.
Meaning: if you load 135 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 761 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for First 25.7 is 15.8.
What is L/B (Length Beam Ratio)?
The l/b ratio for First 25.7 is 2.79.
The ballast ratio for First 25.7 is 28%.
What is Displacement Length Ratio?
The DL-ratio for First 25.7 is 150 which categorizes this boat among 'ultra light racers'.
What is SA/D (Sail Area Displacement ratio)?
The SA/D for First 25.7 with ISO 8666 reference sail is 19.7, with a 135% genua the SA/D is 23.0.
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 23m2 (247 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
Dimensions of sail for fractional rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Mainsail halyard | 25.7 m | (84.2 feet) | 8 mm | (5/16 inch) |
Jib/genoa halyard | 25.7 m | (84.2 feet) | 8 mm | (5/16 inch) |
Spinnaker halyard | 25.7 m | (84.2 feet) | 8 mm | (5/16 inch) |
Jib sheet | 7.7 m | (25.3 feet) | 10 mm | (3/8 inch) |
Genoa sheet | 7.7 m | (25.3 feet) | 10 mm | (3/8 inch) |
Mainsheet | 19.3 m | (63.2 feet) | 10 mm | (3/8 inch) |
Spinnaker sheet | 17.0 m | (55.6 feet) | 10 mm | (3/8 inch) |
Cunningham | 3.5 m | (11.5 feet) | 8 mm | (5/16 inch) |
Kickingstrap | 7.0 m | (23.0 feet) | 8 mm | (5/16 inch) |
Clew-outhaul | 7.0 m | (23.0 feet) | 8 mm | (5/16 inch) |
This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.
We are always looking for new photos. If you can contribute with photos for First 25.7 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.