Udkik.dk

Review of Bavaria 37


Bavaria 37
Bavaria 37.

Basic specs.

sail specifications
The Bavaria 37 is a sailboat designed by the Slovenian maritime architect bureau J&J Design. The Bavaria 37 is built by the German yard Bavaria Yachtbau GmbH.

Looking for a new boat? Find a Bavaria 37 or similar boat for sale

Hull
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

Keel

The Bavaria 37 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load. See immersion rate below.


Engine

The boat is typically equipped with an inboard Volvo Penta MD2030 diesel engine.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Bavaria 37 is about 270 kg/cm, alternatively 1515 lbs/inch.
Meaning: if you load 270 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1515 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Bavaria 37 is 3.05.

Slim Wide 69% 0 50 100
Compared with other similar sailboats it is more spacy than 69% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Bavaria 37 is 38%.

Low High 42% 0 50 100
This ballast ratio shows a righting moment that is higher than 42% of all similar sailboat designs. A righting moment (ability to resist heeling) just below average.


Over- / underrigged

Low High 76% 0 50 100
The Bavaria 37 has more rig than 76% of all similar sailboats, which indicates that the boat is significantly overrigged.


Maintenance

Rig

Dimensions of sail.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 35.2 m(115.5 feet)12 mm(1/2 inch)
Jib/genoa halyard35.2 m(115.5 feet)12 mm(1/2 inch)
Spinnaker halyard35.2 m(115.5 feet)12 mm(1/2 inch)
Jib sheet 11.1 m(36.4 feet)14 mm(0.55 inch)
Genoa sheet11.1 m(36.4 feet)14 mm(0.55 inch)
Mainsheet 27.8 m(91.0 feet)14 mm(0.55 inch)
Spinnaker sheet24.4 m(80.1 feet)14 mm(0.55 inch)
Cunningham3.9 m(12.7 feet)12 mm(1/2 inch)
Kickingstrap7.7 m(25.4 feet)12 mm(1/2 inch)
Clew-outhaul7.7 m(25.4 feet)12 mm(1/2 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.



Finally

We are always looking for new photos. If you can contribute with photos for Bavaria 37 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References